Vox AC4TV Owner's Manual download pdf (Page 4)

REAR PANEL LAYOUT

1. EXTERNAL SPEAKER Jack - This is used to connect the AC4TV to any 16ohm cabinet.

Note ! When an external cabinet is connected, the internal speaker is disconnected.

(FYI - the AC4TV sounds awesome through a VOX V412BN 4 x 12" Cabinet!)

WARNING ! Always use a non-screened VOX approved speaker lead with

the AC4TV Amplifier and extension cabinets.

WARNING ! NEVER operate this amplifier without the loudspeaker load

being connected. Serious damage can occur otherwise.

2. MAINS INPUT - Connect your electricity here with the supplied, detachable Mains (power)

cord.

3. MAINS FUSE - (serious bit) The fuse provides an overall safety protection in the event

your amplifier develops and electrical fault.

The correct value of the fuse is located on the rear panel of your amplifier and should only

be replaced with one of the same value.

WARNING ! Please ensure that your amplifier is connected to the correct

mains power voltage—please check the rear panel rating plate.

If in doubt consult dealer.

WARNING ! This amplifier must always be earthed (grounded) to prevent

the risk of electrical shock.

SPECIFICATIONS

Power Output: 4 Watts RMS into 16 ohm

Loudspeaker: 10 inches 16 ohm VX10 Celestion custom speaker

Dimensions (W x H x D):

350 x 375 x 215 mm (13.78 x 14.76 x 8.46 inches)

Weight: 9.0 Kg (19.84 lbs.)

Included items: Power cable, Owner’s manual

Specifications and appearance are subject to change without notice for improvement.

www.voxamps.com

1 2 3 4 5 6 7 8 9 ... 17 18

No comments

Vox AC4TV Owner's Manual Page 4