Vox VC-12 Specifications download pdf (Page 10)

10

3. Press the VC-12’s BANK UP switch.

The VC-12’s BANK display shows

.

Switch LEDs (1-4) that contain no program

data are off, while those that do contain

program data are on.

4. Use switches 1 through 4 to select the

memory (1, 2, 3, or 4) into which you

want to store the program data. The

selection method you need to use

depends on whether the switch’s LED is

on or off, as follows.

If the switch LED is off, pressing the switch

once will select its memory and its LED will

flash.

If the switch LED is on, you’ll need to press

the switch for at least three seconds in

order to select its memory, and its LED will

flash quickly.

If you want to cancel your selection and

choose another memory, press the switch

again, or press the VC-12’s RECALL

switch. The switch’s LED will stop flashing.

Note: Previously stored program data will be

overwritten by the next step and there is no

undo!

5. To store the program data to the se-

lected memory, press your Valvetronix

amp’s [WRITE] button.

The data is transferred from your

Valvetronix amp and stored in the VC-12.

The corresponding switch LED (1–4)

comes on, indicating that the memory now

contains program data.

6. Turn off your Valvetronix amp, and then

turn it back on again.

That completes the procedure for storing

data.

Loading Program Data

Program data stored in your VC-12 can be

loaded into your Valvetronix amp as follows.

1. Turn off your Valvetronix amp and make

sure it’s connected to the VC-12’s VOX

BUS MAIN connector.

Note: Don’t connect anything to the VC-12’s

VOX BUS SUB connector.

2. On your Valvetronix amp, while holding

down the DELAY [TAP] button and the

REVERB [TYPE] button, turn on your

amp.

The VC-12’s BANK display shows .

3. Press the VC-12’s BANK DOWN switch.

The VC-12’s BANK display shows .

4. Use switches 1 through 4 to select the

memory (1, 2, 3, or 4) containing the

program data that you want to load.

The switch’s LED flashes.

If you want to cancel the procedure at this

point, press the switch again, or press the

VC-12’s RECALL switch.

5. To load the selected memory’s program

data, press the VC-12’s CHANNEL–FX

ON/OFF switch.

The program data is sent to your

Valvetronix amp.

When the data loading process is com-

plete, “4.” appears on your Valvetronix

amp’s BANK display.

6. Turn off your Valvetronix amp, and then

turn it on again.

That completes the procedure for loading

data.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

Comments to this Manuals

No comments