Vox StompLab IIB Specifications download pdf (Page 11)

If the eect parameter that is set as the target function

of the expression pedal is selected and the pedal seing

buon is pressed, “--” will appear briey on the program/

value display and the expression pedal will not have a

target function.

Assigning volume to the pedal

To assign volume to the expression pedal, press the pedal seing

buon aer the master volume ([GBL] VALUE2) appears on

the program/value display. “CP” will appear briey on the

program/value display and the volume can be changed by

using the expression pedal.

Setting the range of the parameter that will be used by

the pedal

Set the range of the eect parameter that will be used by the

expression pedal in the pedal seing mode.

Press and hold the pedal seing buon for approximately 1

second.

The mode will switch to the pedal seing mode and the

expression pedal LED will blink.

Set the value when the expression pedal is fully returned upright

with the VALUE 1 knob.

3. Set the value when the expression pedal is fully pressed down

with the VALUE 2 knob.

The tone will change within the set range when the pedal

is used.

When you nish adjusting your seings, press the pedal seing

buon to exit the pedal seing mode.

5. Enter the edit mode to save the seings.

 Page 12 “Saving a program — [WRITE]”

The set range will return to the previous seing if they

are not saved when the program is switched or when the

power is turned o.

If the program is saved aer using the expression pedal, the

position of the expression pedal (inclined) will be saved as

the set value.

The following values cannot be saved.

• Volume

• Input level to delay eect [DLY]

• Input level to reverb eect [REV]

• Pitch parameter of [MOD] PITCH SHIFT

To control the volume with the pedal, assign the

master level ([GBL] VALUE 2). To control the input

levels of the reverb and delay effects, assign MIX

parameters ([DLY] VALUE 2 and [REV] VALUE 2).

When a target function of the eect pedal is not available,

“- -” appears briey on the program/parameter display

and the pedal cannot be set.

Eect/parameter type and parameter value display

In the Edit mode you can switch the eect names or the VALUE

1 and VALUE 2 values indicated with the Program UP/DOWN

pedals. The tuner



LED will light up when the eect name is

indicated, the tuner center LED will light up when VALUE 1

is indicated and the tuner # LED will light up when VALUE 2

is indicated.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Comments to this Manuals

No comments

Vox StompLab IIB Specifications Page 11

Comments to this Manuals

Related products and manuals for Music Pedal Vox StompLab IIB