Vox StompLab IIB Specifications download pdf (Page 14)

If you are repeatedly unsuccessful in adjusting

the sensitivity, it is possible that the StompLab has

malfunctioned. Please contact your local VOX dealer.

Restoring the factory preset programs

Here’s how to restore (reload) the StompLab’s programs back to

the original factory preset programs.

When you perform this operation, all of the programs you

created and stored inside the StompLab will be erased, and

replaced by the factory programs.

1. While holding down the  buon and the  buon, turn on

the power.

2. The program/value display will indicate “ rL ”, and the TUNER

# and



LEDs will blink. Take your hand o both buons you

had been pressing.

If you decide to cancel the reload operation at this point, press

the  buon.

3. If you wish to reload the factory seings press the  buon.

The program/value display will indicate “ Ld ” and reloading

will begin. When reloading has completed, the program/value

display will indicate “CP ”, and the StompLab will automatically

enter Program select mode.

Never turn o the power while reloading.

Troubleshooting

If you suspect a malfunction, please check the following points. If

this does not resolve the problem, please contact a nearby dealer.

1. Power does not turn on

q Have the baeries have run down?

When the baeries run low, the program/value display will

be dark. We recommend that you replace the baeries as

soon as possible. If baeries become unusable, remove them

immediately. Leaving drained baeries in the unit can cause

malfunctions (such as battery leakage). You should also

remove the baeries if you won’t be using the StompLab for

an extended period of time.

q Make sure the baeries are inserted with the polarities (+, -)

in the correct orientation.

q Is the AC adapter connected to the rear panel DC9V jack?

q Is the AC adapter plugged into an AC outlet?

q Could the AC adapter be damaged?

2. No sound

q Is the volume of your guitar turned down?

q Is your guitar cable connected correctly?

q Is your guitar cable broken?

q Are the [AMP/DR] VALUE 1 (GAIN) or VALUE 2 (LEVEL)

parameters currently set to a low value?

q Are the [Lo] or [Hi] parameters currently set to a low value?

For some amp models, there may be no sound from the amp

if the TREBLE, MIDDLE, and BASS control values are low.

q Is the volume turned down for another eect?

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Comments to this Manuals

No comments

Vox StompLab IIB Specifications Page 14

Comments to this Manuals

Related products and manuals for Music Pedal Vox StompLab IIB